Lotus Blossom Insert with Corner Accents
$8.00
Lotus Blossom Insert with Corner Accents
This listing is for one Lotus Blossom Insert, with four (4) Corner Accents, in your choice of color.
We’ve included a video above, for a more detailed view (Video shows after images.)
We designed this Lotus Blossom Insert with Corner Accents to use in our Stone Edge Vanity Tray Mold, which was designed for “top up” resin pours. These unique Inserts are 3D printed using PLA, and are available in your choice of Silver or Bronze, with a textured finish.
The Lotus Blossom Insert and Corner Accents can be glued in our Mold, or added to wet resin. Once the resin has set up, you can personalize your design, by adding paints or resin colored with Mica, Glitter, or Inks, into the open areas of the Insert/Accents.
NOTE: The finished Vanity Tray is shown as a sample of what can be created using this Lotus Blossom Insert with Corner Accents, and it is not included.
We have uploaded a Video Tutorial, showing how to use this Lotus Blossom Insert with Corner Accents, in our Stone Edge Vanity Tray Mold, on our YouTube Channel. Check out the link below to watch it.
Available Colors: Silver or Bronze
Lotus Blossom Measurement: approx. 5.96” L x 4.73” W x .20” H
Corner Accent Measurement: approx. 2.60” L x 1.17” W x .20” H
Crystal Size Comparison Chart
Dust/Sand: Not measurable
Triple Zero (000): Under 1 mm
Double Zero (00): 1 to 3 mm
Zero (0): 3 to 5 mm
S1: 4 to 6 mm
L1: 5 to 7 mm
Size 2: 6 to 10 mm
Extra Small: 8 to 15 mm
Small: 12 to 20 mm
Medium: 18 to 25 mm
Large: 20 to 30 mm
XL: 30 to 50 mm
NOTE: Color, size, and shape will vary due to the fact that these are natural stones. Also, colors may vary, depending on your monitor settings, and may differ from the actual color of the item.
• Never use a torch or open flame with Silicone Molds.
• Never use anything sharp or abrasive, inside the mold.
• Always use high quality Epoxy Resin products and follow the mixing and pouring directions for that product.
• Keep your mold clean - Keep dust away by storing it in a plastic bag, and only use tape or warm water to clean it.
• The glossy surface of molds will fade away with repeated use. When this happens you will have to topcoat your finished piece, or purchase a new mold.
